Page 1 of 1

Dslogic DECODING CAN message

PostPosted: Sat Jun 20, 2015 10:13 pm
by stealth
I am trying to analyse a known CAN signal (8 numeric char @ 500baud with 50ms delay between transmission). The signal is sent at 500kbPs and the logic analyser measures the signal correctly, I have confirmed this with an oscilloscope. However I can not get the DECODER to come up with a correct decode. I set to 500,000 bits/sec but it thinks its reading an extended address 29 and not 11, though I am not quire sure of the sample point (%) and its use?? maybe you can explain. I have tried a number of setting but nothing close?? Note I am using the latest DSLOGIC windows version V 0.9.3.1

Re: Dslogic DECODING CAN message

PostPosted: Tue Jun 30, 2015 1:16 am
by Andy
Hi Stealth,

Could you upload some pictures about your issues.
As we know, the default setting of CAN analyzer is working well.
Does it happens only at 500kbps ? or any setting?