Page 1 of 1


PostPosted: Mon May 18, 2015 3:38 pm
by DenJohX
Hi, here is my first question in this forum! Nice project btw.

Now the question: What does those pins are for? The wiki doesn't says anything about them.

Re: TO, TI, CKL?

PostPosted: Thu Jun 11, 2015 10:26 pm
by Andy
CK: external clock input for state sample. Assume that you have a bus with clock, you can input the clock using this channel to get a synchronous sample data.

TI: external trigger input.
TO: external trigger output.
The function of these two channel haven't been supported by current software version. It can be used to multiple devices cascade or just a general input/output signal.