Page 1 of 1

LSM303DLHC working with Wireless

PostPosted: Fri Sep 05, 2014 11:24 am
by salmanisheikh
I'm trying to get the LSM303DHLC triple-axis accelerometer working with the DSL Logic wireless extension and probe. I programmed the probe with an Arduino sketch to take accel and mag data and transmit it to the extension. I programmed the extension to become a receiver and print out the data (initially on the serial monitor of the Arduino to see if anything is coming in). I see nothing. I used the rx_wireless and tx_wireless from the DSL github page to create my sketches. Anybody able to help me figure this out? I am not sure how to upload the Arduino sketches?

Re: LSM303DLHC working with Wireless

PostPosted: Sat Sep 06, 2014 1:50 am
by Andy
Hi salmanisheikh,

Did you test the wireless probe and extension according to our instruction on wiki? ... cquisition