Page 1 of 1

how to debug decoders?

PostPosted: Thu Jun 02, 2016 9:26 am
by antus
I am attempting to develop a decoder plugin for dsview on windows.

I have noticed that if there is a syntax error in the python code, the decoder does not list in the gui when I start dsview. However, I can not find a way to see the output from the python interpreter. This would be invaluable in tracking down the problems.

How can we see the python interpreter stdout/stderr?

Re: how to debug decoders?

PostPosted: Sat Aug 13, 2016 11:26 pm
by Andy
In v0.96, if the decoder can be loaded, DSView will display the run error on the decoder channel.
Hope this can help you.