Page 1 of 1

firmware 0.9.4.1 - Trigg problem

PostPosted: Sat Jul 04, 2015 7:09 pm
by wifipower
Dear,

I just install the 0.9.4.1 beta

when I go to the trigger setup, advanced trigger selected/Stage trigger, I can't see the channel 0 in the list !
only from 1 to 15 !

that was worked with previous 0.9.2 version

thanks to update please, regards

Re: firmware 0.9.4.1 - Trigg problem

PostPosted: Mon Aug 03, 2015 1:54 am
by Andy
Thanks for the feedback.
It's just a display issue.
The lineedit is including the channel 0 setting.