Protocol decoder

Topics about DSLogic software development
Hi,

I tried adding a new protocol decoder to the project based on a modified version of an existing protocol. The __pycache__ folder gets created when I run DSView, but the new protocol is not on the list. What do I have to do to test it?

TL
Timelord
 
Posts: 1
Joined: Tue Jul 21, 2015 3:42 pm

Hi,

This may caused by syntax error of the your new decoder.
In a normal case, you just need to copy your decoder into the "Decoders" directory under the setup path.

You can also check the error in a debug environment.
Andy
Site Admin
 
Posts: 149
Joined: Fri Jul 11, 2014 9:20 am


Return to DSLogic Software

Who is online
Users browsing this forum: Bing [Bot] and 1 guest