Page 1 of 1

Protocol decoder

PostPosted: Tue Jul 21, 2015 3:46 pm
by Timelord
Hi,

I tried adding a new protocol decoder to the project based on a modified version of an existing protocol. The __pycache__ folder gets created when I run DSView, but the new protocol is not on the list. What do I have to do to test it?

TL

Re: Protocol decoder

PostPosted: Mon Aug 03, 2015 1:57 am
by Andy
Hi,

This may caused by syntax error of the your new decoder.
In a normal case, you just need to copy your decoder into the "Decoders" directory under the setup path.

You can also check the error in a debug environment.