Page 1 of 1

new IR raw protocol decoder please ?

PostPosted: Mon Feb 23, 2015 9:40 pm
by wifipower
hi,

I wish to decode some basic China IR remote control.
they are all based on 38KHz modulation and simple code (not NEC or RC5/6).

please can you add this protocol decoder on next release ?

thanks, regards

Re: new IR raw protocol decoder please ?

PostPosted: Wed Apr 15, 2015 10:56 pm
by Andy
Hi wifipower,

You should tell us what is the simple code?
Is there any specifications for the simple code?
Without this, we can't release any new protocol.

Thanks.

Re: new IR raw protocol decoder please ?

PostPosted: Wed May 06, 2015 6:18 pm
by wifipower
hi Andy

in fact it is NEC protocol but with more or less precision in the timing
so the analyzer don't decode it every time !

thanks, regards

Re: new IR raw protocol decoder please ?

PostPosted: Thu Jun 11, 2015 10:21 pm
by Andy
Hi wifipower,

IR NEC protocol is available in current software.
Do you means current NEC protocol has a too strict limits on timing?

Re: new IR raw protocol decoder please ?

PostPosted: Sat Jul 04, 2015 7:12 pm
by wifipower
hi Andy

yes or the low cost Chinese remote I use have poor timing tolerances !

regards